30KN Sine Wave Vibration Shaker Table for Structural Testing 5-2600Hz

Electro-dynamic Vibration Testing Equipment is widely used in defense, aviation, aerospace, communications, electronics, automobiles, and home appliance industries. This system is designed for early fault detection, simulating actual working conditions, and structural strength testing.

• Higher acceleration and working frequency with smaller carrier mass
• Integrated design with excellent stiffness for easy installation
• Reinforced welding body provides superior damping effect
• Built-in vibration isolation system minimizes ground vibration propagation
• Supports sine wave, FM, sweep, programmable, and logarithmic functions

• Follow control manual procedures precisely
• Use recovery method steps for operation errors
• Press external start switch before use
• Table body should be leveled and foot sleeves fixed
• Do not adjust amplitude too large before/after boot
• Non-special tests should use full wave test
• Cut all power when not in use and keep clean